That would cause the brake lights to stop working. I replaced pig tail, replaced pig tail plug from truck checked fuses. 2011 freightliner m2 with no brake lights and cruise does not disengage when brake pedal is pressed.truck has a aava solenoid not a amu. So I ran all of the air out of my system and the brake lights … All the Toad lights worked the rigs running, turnsignal, clearance lights worked but "Brake Lights" did'nt. Got my 98 W900 back from the shop and suddenly my brake lights are getting stuck on. We got stooped once or twice a week in that thing for one light or another being out. Freightliner Owners Club. My AC was corrected and all lights working. Doing a cursory check of all lights I find I have no brake lights. The service crew contacted F-liner and requested a detailed schematic to locate the Diodes. I'm hoping someone can give me a quick pointer on troubleshooting because I'm supposed to be heading for Texas tomorrow. No fun finding out the lights don't work from a state trooper! 2018 cascadia i found the apparently water get on that brake sensor and rust the tip causing brake lights problems. The first time I had this problem. The part that was replaced to correct my AC problem was the rear power distribution module which is the part being replaced in the recall. Join Date: Oct 2002. Posts: 2,300 Brake Lights not Working. The problem is that the right brake lights are not working, but the center brake light and the left side brake lights are working as well. Turn, running, and flasher lights work fine, so it appears the light fixtures themselves are OK. #1316 wire from brake switch to chm has a weak ground all the time and strong ground when pedal is depressed. When I left for the Freightliner service center this morning it was still dark and I realized that none of my rear or running or brake lights were working. Also, the trailer lights have the same problem (all lights work fine except the right brake light will not light). Accordingly, there should be no grounding the wife has a 07 freightliner coronado. And finally, if the brake lights for some reason draw more power than the tow package wiring can handle then the lights will either not work or it will blow a fuse. --Just after my buddy and I got our licenses, he had a Simca, a French auto with ALL the switches on the steering wheel hub. Both sides of the turn signals work and the running lights work on both sides as well. I too had the same problem with my 05 Freightliner chassis. she had the head light wiring harness replaced and also replaced fancy taillights. just not brake lights. Location: Fairview TX. If the pin slides out farther, the brake pedal could detach, making it harder to stop the truck. If they are drawing too much power then switching to LED lights will solve that problem because they draw a fraction of the power compared to incandescent lights. soon there after the brake lights to the trailers stop working, the turn signals, four- way and tail lights all work. I am working on a 2007 Freightliner M2 single axle road tractor.Id number 1FUBCXDJ47HX48489 the right side brake light on the tractor will not work…